Pps 43 Barrel Pin - Pps43 12 inch custom barrel in 9mm. Perfect for your suppressor or barrel extension for 16 inch compliance. Machined from 4140 steel ; Requires barrel pin & riveting. These are essential parts for any pps43. Bushing is not included. May show some signs of wear,. One of the key components of the receiver group is the barrel, which is responsible for guiding the fired bullet and providing stability and accuracy to the projectile. It is securely attached to the. The original pin is 0. 235, and the h&k (large) stock pin is. 02958, it is just a bit short for the pps43c, so my solution was to countersink with a 13/32 drill bit, and flatten it out. Pps 43 barrel trunnion $30. 00. Quick view add to cart the item has been added. Quick view add to cart the item has been. Pps43 12 inch custom barrel in 9mm. Perfect for your suppressor or barrel extension for 16 inch compliance. Can anyone tell me how to remove the barrel pin on pps43? I've tried using a hammer and punch but didn't have any luck. Either drill it with an undersized drill (pin is at an angle) or grind off. It's removal isn't necessary to remove the bolt or barrel. I do have the correct 9mm barrel so i am actually thinking about setting up the original barrel and the 9mm barrel so that they are retained with a. 250 push pin rather than a rivet.
Pps43 12 inch custom barrel in 9mm. Perfect for your suppressor or barrel extension for 16 inch compliance. Machined from 4140 steel ; Requires barrel pin & riveting. These are essential parts for any pps43.